Waterloo F1526A2 Manual de usuario descargar pdf (Pagina 4)

BB(2)

EE(2)

FF(2)

• Remove and reuse the top fasteners from the top back of

the workbench.

• Attach (2) A to workbench, as shown, using existing

hardware and (2) BB, (2) EE and (2) FF.

• Finger tighten.

Existing Hardware

Flange

pointed back

STEP 1:

Stop

Lance

Slot

Lubricate

• Empty the drawer.

• Fully extend the drawer.

Release

• To reinstall, carefully align

the slides and slowly push

the drawer into the unit until

the drawer stops.

Lever Style - Lift or lower (depending on the

slide) the release lever on both sides, (this

allows the slides to ride over the stops.) Pull

out to remove.

Tab Style - Depress the release tabs on

both sides, (this allows the slides to ride over

the stops.) Pull out to remove.

WARNING: Backwall with Metal Pegboard is only to be attached to

one of the following Workbenches: WB5002, WB5003, WB5507.

NOTE: To assemble the Backwall, the drawers and top must first be

removed from the workbench.

REMOVING AND INSTALLING DRAWERS:

FRICTION SLIDES

• Empty the drawer.

• Fully extend the drawer. Push it back a quarter of an inch, (6

mm).

• Insert a screwdriver into the slot in the slide and push in on the

stop until it clears the lance.

• Repeat the procedure on the other slide and remove the drawer.

• To reinstall the drawer, pry the stop far enough out to engage the

lance and push the drawer onto the slides until the stops pass

over the lances.

BALL BEARING SLIDES

TOP REMOVAL:

• Remove and reuse fasteners from wood top.

• Remove top from workbench base.

ASSEMBLY

1 2 3 4 5 6 7 8 9 ... 27 28

Comentarios a estos manuales

Sin comentarios

Waterloo F1526A2 Manual de usuario Pagina 4

Comentarios a estos manuales